The cost to replace your gas furnace will vary based on the type and size of furnace you select, labor and installation costs, and any repairs your HVAC system may need. Nationally, average HVAC prices for a heating specialist range between $1,800 and $2,500. It’s important to select the right size gas furnace for your heating needs. A furnace that’s too small won’t heat your house properly, while a furnace that’s too large will run inefficiently, cycling on and off and likely breaking down sooner. HVAC specialists calculate your exact heat needs by measuring your home and incorporating variables such as the regional climate and your home’s level of insulation. Retail pricing for gas furnaces can range from $650 up to $3,000 and more. The higher the AFUE (annual fuel utilization efficiency) rating of the furnace, the more efficient it is at turning fuel into heat and the lower your carbon footprint and utility bill will be. HVAC installation costs are often based on an hourly rate and can range from under $50 to over $100 per hour, depending on the company and the furnace being installed. Higher-end furnaces cost more to install because they require added labor and expertise. For a typical installation, it might take two HVAC installation pros one day or less to remove your old furnace and replace it with a new one.

HVAC Repair Company


Nytech Heating and Cooling has proudly served Castle Rock, and Douglas county customers for over 10 years. We are passionate about customer service and truly care about your family and your home. We don't believe in cutting corners to boost profits. We do what it takes to get the job done correctly. Douglas County is our Home and we genuinely care about our neighbors.
Mitsubishi Electric is a world leader in air conditioning systems for residential, commercial and industrial use. Challenged to create air conditioning systems that provide exemplary performance in the wide-ranging climatic conditions found throughout Japan, our engineers develop amazingly sophisticated yet durable units and systems capable of constant use under virtually any natural climatic condition on earth.
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
When your furnace needs immediate repair, trust the professionals at BGE HOME. We understand that furnace problems are more than a mere inconvenience – they can have a serious impact on the health and safety of you and your family. Our technicians are available 24-hours a day for emergency repairs. Click to schedule your repair and have peace-of-mind knowing that a licensed, certified HVAC technician will have your system up and running as quickly as possible. For 24-hour emergency furnace repair service, call 1-888-243-4663.
Locally owned and family operated, M and M, Heating & Cooling, Plumbing & Electrical customizes solutions to perfectly fit your requirements and lifestyle. We specialize in a wide range of services including plumbing, water heating, indoor air quality, and residential and commercial temperature control. Our team of highly trained and certified technicians are fully licensed and insured, adhere to strict service procedures, and meet exacting standards of quality. Call on M and M, Heating & Cooling, Plumbing & Electrical at (720) 443-6119 for dedicated service throughout Longmont, CO & surrounding areas, and have confidence in a rewarding experience and long-term results. With over eighteen years of satisfied customers, we take great pride in a job done right.

2Be sure the furnace’s circuit breaker is on or that its fuse has not blown. Check both the main electrical panel and any secondary subpanels that supply power to the unit. If the circuit has blown or tripped, reset the circuit breaker by flipping it all the way off and then on again. Or replace the fuse. If the circuit blows again, there is probably a short in the electrical system providing power to the furnace. For this, you may need to call an electrical contractor.
We have strived extremely hard to become the premier HVAC repair & installation choice for the peole of Columbia, Maryland. We pride ourselves on being the first HVAC company in all of Maryland to be awarded with Factory Authorized status. We have also earned the Distinguished Dealer Award by the Carrier Corporation for our strong & consistent dedication to superior local heating and air conditioning work in addition to exceptional customer satisfaction.
Expect exceptional service and superior quality. By consistently meeting rigorous national standards for performance, Deljo Heating & Cooling is distinguished as a Carrier Factory Authorized Dealer. We continue to reach high expectations for ethical business practices year after year. By maintaining all required local licenses, complete insurance & liability coverage, and fulfillment of warranty specifications, we provide Chicago area home and business owners a team of support they can count on.

High-efficiency condensing furnaces (90% AFUE and above) are a bit more complex than conventional furnaces. The main differences between a conventional and condensing furnace are the heat exchanger technology used to extract heat from the combustion process and the method used to exhaust the combustion gases. In these ways, the furnaces are very different. The condensing furnace does not have a significantly more efficient combustion process than does a conventional furnace; both use gas burners with electronic ignition. The difference lies in that the condensing furnace has a more efficient heat extraction process after combustion.


As a Bryant® dealer, with a wide variety of products to choose from, we can keep your family healthy and feeling comfortable all year long. We carry a complete line of indoor comfort equipment with innovations that raise the standards of comfort and reliability, including air conditioners, heat pumps, gas furnaces, programmable thermostats, humidifiers, ductless split systems, geothermal systems, boilers, air cleaners, ultra violet lights, ventilators and zoning products. Let the experts at Moab Heat - N - Cool help you customize a solution that's right for you.
High-efficiency condensing furnaces (90% AFUE and above) are a bit more complex than conventional furnaces. The main differences between a conventional and condensing furnace are the heat exchanger technology used to extract heat from the combustion process and the method used to exhaust the combustion gases. In these ways, the furnaces are very different. The condensing furnace does not have a significantly more efficient combustion process than does a conventional furnace; both use gas burners with electronic ignition. The difference lies in that the condensing furnace has a more efficient heat extraction process after combustion.
Air conditioners can create a lot of water because they remove moisture from the air. To get rid of this, they have a [usually plastic] drain pipe that comes out of the side of the air handler. Over time, algae can block this pipe and, when it does, the AC won’t work. In fact, some condensate drains have a float switch that won’t let the AC run if water backs-up. Water can also puddle around the unit or flood the area. To deal with condensate problems, please see Air Conditioner Leaks Water, below.

Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.


The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack. Then you can re-tighten the tension once the belt is in place. Check the manufacturer’s specifications for proper tension—in most cases, the belt should deflect about an inch when you press down on it.
A contactor is a $25 mechanical relay that uses low-voltage power from the thermostat to switch 220-volt high-amperage current to the compressor and condenser fan. AC contactors can wear out and are at the top of the list of common air conditioning service failures. Even if your contactor is working, it pays to replace it every five years or so. Unscrew the old contactor before removing the wires. Then move the wires to the new unit (photo 6).
If your compressor doesn’t have an overload button and you hear it humming or buzzing, poke a screwdriver or stick down through the top grille and try to spin the fan blades clockwise. If doing this gives the fan enough of a boost to get it going, the unit has a faulty capacitor that must be replaced. See How to Test and Replace an AC Run Capacitor, above.
Geothermal Heating and Cooling systems are unmatched in every way. This green alternative to temperature control is three times more efficient than conventional systems. Recognized by the US Environmental Protection Agency as the most environmentally-friendly option available today, installation of a geothermal HVAC system translates into a 50% reduction in heating costs, 30% reduction in cooling costs, and a 65% potential savings on hot water costs.  Sky Heating & Air Conditioning is now the largest WaterFurnace geothermal contractor west of Iowa. Our team of experienced professionals offer conscientious and skilled start-to-finish installation and service.  We specialize in outstanding geothermal HVAC systems, adding value and enjoyment to your home through sustainable solutions to year round temperature control. Contact Sky Heating & Air Conditioning for geothermal heat pump installation in Portland.
Although problems can arise for any variety of reasons, there are ways for homeowners to reduce the probability of an air conditioner breakdown. Whether it’s disregarding strange sounds, not switching out your air filters or missing your annual air conditioner service, you can impact how often you’ll need AC repair. However, when your system breaks down and you admit AC repair is necessary, it’s important to always call the professionals. With warmer temps in Paso Robles, you don’t want to take on the risk of trying to fix things by yourself. Paso Robles Heating and Air has technicians who are experienced in all AC situations and how to fix them, and we can get the job done right the first time. When performing a repair, it's crucial to source professional HVAC contractors. 
Vredevoogd Heating & Cooling Grand Rapids employs more than 80 people who are proud to work under the Vredevoogd Heating & Cooling banner. Each team member shares our company values for service excellence. All of our employees are intensely screened and background checked so that you have peace of mind when they enter your home. Moreover, our technicians are certified to work in the HVAC industry and provide the level of expertise that our customers expect from Vredevoogd Heating & Cooling. We back our technicians’ work and continue to make training a priority so that all of our techs are familiar with the latest HVAC models and advances. Our customers deserve the best, so the best is what we deliver to each and every job.
Arundel Cooling has been proudly providing HVAC services in Columbia, Maryland for more than 40 years now. With this much experience, we bring our extensive knowledge and expertise to every HVAC repair or installation job we complete. No matter what time of day, Arundel Cooling and Heating will be there for you. We make ourselves available 24 hours a day, 7 days a week, so whether you need to schedule an appointment or you’re having a heating and cooling emergency, you can count on Arundel Cooling and Heating.
Since 1960, A & A Air Conditioning Heating & Sheet Metal has provided a trusted source of HVAC and water heating services to residential and commercial customers throughout Grass Valley & surrounding areas.  Over three generations, we’ve continued to uphold the honest practices, affordable pricing, and conscientious workmanship that has always set us apart.  Our solid history ensures a more comprehensive knowledge of local weather demands, product reliability, and ongoing support.  Have complete confidence that A & A Air Conditioning Heating & Sheet Metal will respond quickly, complete all projects to exacting standards, and still be around to stand behind our work, in the years to come.
To qualify as a Certified Daikin Comfort Pro Dealer, Green Valley Cooling & Heating maintains exceptionally high standards of business practices, technical expertise, and customer approval ratings.  Our loyal customers, amazing community of support, dedicated team members, and vendors have all contributed to celebrating 50 years in business, and we see it as a benchmark for future achievement. Rest assured, at Green Valley Cooling & Heating we continue find new ways to exceed your expectations.
The professionals here at Brothers Plumbing, Heating and Electric are well trained, experienced and seasoned experts. We have been the go-to plumbing, electrical and HVAC company in the area for over 35 years and we always come highly recommended by our many satisfied customers. We offer a 100% satisfaction guarantee, have an A+ Rating with the BBB, won the Thornton “People’s Choice Award” for 2016, drug test and background check all of our employees, email you a picture of the technician who will be providing the service before arrival and call once the service is complete to ensure 100% satisfaction. So what are you waiting for? With our competitive pricing, trained and experienced technicians, and well-rounded list of home services, we’re clearly the company to trust. Get in touch with us here at Brothers Plumbing, Heating and Electric to schedule your needed service today!

At Genz-Ryan, we are here for you 24 hours a day, 7 days a week so you can count on us for all your heating repair work in the Minneapolis area. Our furnace repair technicians are well-trained and experienced. They’re ready to take care of any heating issue that you may have. We are a Lennox Premier Furnace Dealer and provide expert furnace repair service for most of the Minneapolis/St. Paul area. For over 60 years we have been getting the job done right the first time.

Remember the way service used to be? Remember when a company did what it promised? Remember when service people gave service? They still do at Coomes Air Conditioning & Heating. Our technicians are polite, clean, and well groomed. Our technicians will show up when promised and clean up before they leave. They will take the time to explain things to you and offer you options. And, they will do the job right, the first time, every time. Call Coomes Air Conditioning & Heating today.

At Horizon Services, we strive to go above and beyond for every one of our clients. We offer honest, upfront pricing in writing for every service we provide, as well as flexible scheduling to suit your needs, industry leading warranties, and a 100% customer satisfaction guarantee. When you call on us for heating services, our technicians will arrive on-time, every time. If we're even one minute later than the provided window of time, you don't pay. We understand that dealing with a broken or malfunctioning heating system can be incredibly frustrating. Let us turn your stressful situation into a thing of the past!
Welzig Heating & Air is on call, 24 hours a day, 365 days, making sure that the skilled assistance you need is always available.   There’s no need to struggle with decreased performance from your air conditioner.   Even small aggravations, such as elevated sound levels, strange smells, or longer running times, are warning signs of larger issues and usually add up to higher running costs.   When you trust your cooling equipment to Welzig Heating & Air, we work to not only resolve pressing issues. but ensure reliability, efficiency, and longevity.   A thorough inspection often protects against degraded air quality, property damage, and premature system failure.   We work on all makes and models of air conditioners, and with every repair we tackle, our team of dedicated technicians earn your satisfaction.   Through exemplary customer service, ethical business practices, and exacting standards, Welzig Heating & Air provides superior solutions to homeowners across Boulder, Longmont, Louisville, Lafayette, CO & more.
When our Denver heating company provides you with maintenance checks before the cold of winter sets in, you will be saving money in several different ways. One of the benefits of a maintenance plan is our technicians will be less likely to have to make repairs throughout the year as long as the system is properly maintained. Our Denver heating company will have your system running at its most efficient, helping to reduce your utility bills each month. An added benefit of a more efficiently running system is the positive environmental effect that it will have.
×