The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack. Then you can re-tighten the tension once the belt is in place. Check the manufacturer’s specifications for proper tension—in most cases, the belt should deflect about an inch when you press down on it.
A Bit Pricy For the Work Done But It Was A Necessary Fix That Required The Tech To Make A Trip To Home Depot And Back. When Calling For The Repair I Expected A Much More Severe Problem That If I Had Been Correct Would Have Been A Much More Expensive Fix. The Problem Turned Out To Be A Simple Problem That Required The Tech To Make A Trip To Home Depot For A $10 Part Afterwhich He Was Able To R&R The Part In About Two Minutes. Problem Solved.