The cost to replace your gas furnace will vary based on the type and size of furnace you select, labor and installation costs, and any repairs your HVAC system may need. Nationally, average HVAC prices for a heating specialist range between $1,800 and $2,500. It’s important to select the right size gas furnace for your heating needs. A furnace that’s too small won’t heat your house properly, while a furnace that’s too large will run inefficiently, cycling on and off and likely breaking down sooner. HVAC specialists calculate your exact heat needs by measuring your home and incorporating variables such as the regional climate and your home’s level of insulation. Retail pricing for gas furnaces can range from $650 up to $3,000 and more. The higher the AFUE (annual fuel utilization efficiency) rating of the furnace, the more efficient it is at turning fuel into heat and the lower your carbon footprint and utility bill will be. HVAC installation costs are often based on an hourly rate and can range from under $50 to over $100 per hour, depending on the company and the furnace being installed. Higher-end furnaces cost more to install because they require added labor and expertise. For a typical installation, it might take two HVAC installation pros one day or less to remove your old furnace and replace it with a new one.
HVAC Repair Company
If you find yourself with a need today, don’t hesitate to contact us now. We want to prove to you why we have such stellar ratings for quality and customer satisfaction in Cary. To easily make an appointment, you can contact us on our website, chat online, or call us at 919-578-4329. With one conversation, we’ll show you why you can be comfortable and confident in your decision to work with us. Find out today what your friends and neighbors in Cary have already found: You can rely on Service Experts.
A Bit Pricy For the Work Done But It Was A Necessary Fix That Required The Tech To Make A Trip To Home Depot And Back. When Calling For The Repair I Expected A Much More Severe Problem That If I Had Been Correct Would Have Been A Much More Expensive Fix. The Problem Turned Out To Be A Simple Problem That Required The Tech To Make A Trip To Home Depot For A $10 Part Afterwhich He Was Able To R&R The Part In About Two Minutes. Problem Solved.